DIY Vertical Rifle Rack

[orangehouse]

Hi! I am relatively new to this forum. In the past months I have been reading some of the posts made by forumers.

This will be my first contribution. By the way, I just revived this hobby. It started when I had my old Garco .22 CO2 rifle repaired. I was looking for a rifle rest that will allow me to zero my iron sights, then my scope.

This was my first attempt. Made out of scrap 1"x2" lumber.




I soon realized that once the scopes are installed, I can no longer just place my rifles on the table or lean them against the wall in between shooting. So, I looked for available racks for sale. I only found one and it was expensive!

I searched the internet for ideas and then I designed my own that would fit my requirements. Might as well DIY! Getting a new rack was half the fun. I had a great time doing this project. So after playing around with the design in powerpoint, off I went shopping in Wilcon Depot. Total cost of my materials was approx. P 1000 only!!











I was able to create extra portable rests with the leftover lumber.



I only have 3 rifles but I made a rack for 4 slots.

Hopefully, I can fill that with a PCP. I don't have one yet.

[snyper]

Nice Job bro! Thanks for sharing. As they say half the fun is making the project itself.